Monthly Archives: July 2014

William Henry “Engraved Longhorn Beetle Knife” Part 3

Posted on July 5, 2014 by metal_musings

Time to begin carving the beetle.  I started by engraving parallel cuts between the legs Koupit Lasix v Praze , leaving a little metal at the edge of the inlay pocket.  I don’t want to cut into the pocket and weaken … Continue reading →

Posted in Carving, Engraved Knife, William Henry knife | Tagged , , , , , , | Leave a comment

William Henry “Engraved Longhorn Beetle Knife” Part 2

Posted on July 3, 2014 by metal_musings

Installing the Shibuichi Pocket Inlay Today is all about getting the shibuichi inlay into the stainless steel scales.  As far as I’m concerned, this is the make it or break it phase.  If I should fail to get the inlay … Continue reading →

Posted in Carving, Engraved Knife, William Henry knife | Tagged , , , , , , , | Leave a comment

William Henry “Engraved Longhorn Beetle Knife” Part 1

Posted on July 1, 2014 by metal_musings

Well, after finishing up the little copper overlay titanium owl pendant, I’m back into the swing of things to begin my next William Henry (www.williamhenry.com) commission, a small B10 model folding knife. I started by engraving the basic layout of … Continue reading →

Posted in Carving, Engraved Knife, William Henry knife | Tagged , , , | Leave a comment