William Henry “Engraved Longhorn Beetle Knife” Part 10

William_Henry_B10_Longhorn_Beetle_68
Above, I’ve completed most of the bark, save for a small area where I might place a tiny spider – I’ll look at it while in front of the TV tonight, and decide if it is an enhancement, or just an addition. Just like the bark on the front, I’ve used two sizes of carbide burs, followed by selective use of a square graver, and then followed by a large punch.

Thanks for looking!

 

This entry was posted in Carving, Engraved Knife, William Henry knife and tagged , , , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *